Pioneer VSX-52TX Owner's Manual - Page 73
Remote control
View all Pioneer VSX-52TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Additional information 12 Symptom Cause Remedy When playing certain discs, none of the receiver's format indicators light. • The audio format of the disc is not 5.1/6.1 • This is not a malfunction. Check the disc packaging for channel. details of the audio formats available on the disc. When playing a disc, the • The input signal type is set to analog. 2 PL II or Neo:6 indicator lights on the receiver. • A two channel soundtrack is currently playing. • Set the receiver to AUTO or DIGITAL (see Choosing the input signal on page 33). • This is not a malfunction. Check the disc packaging for details of the audio formats available on the disc. • The soundtrack currently playing is encoded using Dolby Surround. • This is not a malfunction. Check the disc packaging for details of the audio formats available on the disc. During playback of a Surround •The source may be Dolby Surround EX / DTS • Set to Extended ON (see Using the surround back EX or DTS ES source on the ES software, but it has no flag to indicate it is channel (Extended mode) on page 34) then switch to the Extended AUTO setting, the EX 6.1 compatible. THX Surround EX or Standard EX listening mode (see and ES indicators don't light, or Listening in surround sound on page 30). the signal is not properly processed. Remote control Symptom Cause Remedy Cannot be remote controlled. • The remote control batteries have worn out. • Replace the batteries (see Loading the batteries on page 7). • Too far away or improper angle of operation. • Operate within 23 feet and a 30º angle of the remote sensor on the front panel (see Operating range of remote control unit on page 29). • There is an obstacle between the receiver • Remove the obstacle or move to another place. and the remote control. • Strong light such as fluorescent light is • Avoid exposing the remote sensor on the front panel to shining onto the unit's remote control sensor. direct light. • Something is plugged into the CONTROL IN • Unplug the cable from the CONTROL IN jack and use jack. remote normally (see Operating other Pioneer components on page 22). • The IR receiver type is mismatched with the • Disconnect the IR receiver from the rear panel or set to setting. the other IR receiver type (see Multi Room Setup on page 67). Other components can't be operated with the system remote. • The preset code settings are wrong. • The batteries wore out and the system settings were cleared. • Input the correct preset code. • Reset the proper system settings. The SR cable is connected, but • The SR cable hasn't been connected the connected components can't properly. be operated with the remote. • Reinsert the SR cable, making sure it's connected to the right jack (see Operating other Pioneer components on page 22). • The rest of the component connections have not been made. • Make sure an analog connection has been made between the units. • The component you have hooked up is not a • This feature only works with Pioneer products. Pioneer product. Note • If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions. 73 En