Pioneer VSX-LX305 Instruction Manual English - Page 126
Power Management, Auto Standby in HDMI Standby Through Default Value: On/Off
View all Pioneer VSX-LX305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Hardware Power Management Change the settings for the power-save function. Sleep Timer (Default Value: Off) 30 minutes, 60 minutes, 90 minutes Off You can allow the unit to enter standby automatically when the specified time elapsed. Select a value from "30 minutes", "60 minutes" and "90 minutes". Does not turn the unit to standby automatically. Auto Standby (Default Value: On/Off) This setting allows the unit to enter standby mode automatically after 20 minutes of inactivity without any video or audio input. (When "USB Power Out at Standby" or "Network Standby" is enabled, the unit enters the HYBRID STANDBY mode which minimizes the increase in power consumption.) • Default values vary depending on the regions. On The unit will automatically enter standby mode ("AUTO STBY" will light). • "Auto Standby" is displayed on the main unit's display and TV screen 30 seconds before entering standby mode. • "Auto Standby" does not work when Zone 2/Zone 3 is active. Off The unit will not automatically enter standby mode. Setup Auto Standby in HDMI Standby Through (Default Value: On/Off) Enable or disable "Auto Standby" while "HDMI Standby Through" is on. • Default values vary depending on the regions. On The setting will be enabled. • This setting cannot be set to "On" if "Auto Standby" and "HDMI Standby Through" are set to "Off". Off The setting will be disabled. USB Power Out at Standby (Default Value: Off) Devices connected to the USB port (5 V/1 A) on the rear of the unit can be supplied with electricity even when this unit is in standby mode when this function is "On". • Supply of power to USB devices in the standby mode is not supported for the USB port on the front panel. • When this function is set to "On", the power consumption in standby state increases, however, the increase in power consumption is minimized by automatically entering the HYBRID STANDBY mode where only the essential circuits operate. 126