Pioneer VSX-LX305 Instruction Manual English - Page 154
Dirac Live, Measuring with Dirac Live, this unit. Refer to Pioneer Remote App
View all Pioneer VSX-LX305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Dirac Live Measuring with Dirac Live Use the Pioneer Remote App to use Dirac Live to take measurements. Use the most recent version. Note that you cannot make settings using operations on this unit. Refer to "Pioneer Remote App" ( →p153) for information about the app. Also have a tripod ready to set up the speaker setup microphone. • Calibration takes about 20 minutes to be completed. Dirac Live® is an advanced room correction technology developed by Dirac Research. As one of the most advanced room correction technology available on the market, Dirac Live helps listeners to correct for one of the weakest components in the audio chain: the listening room. Dirac Live not only corrects the frequency response, but also the impulse response of the loudspeakers in a room, yielding improved imaging and timbre, better clarity, tighter bass, and less early reflections, as well as reduced resonances and room modes. 1. Start the Pioneer Remote App and tap the unit when displayed. 2. Tap " " at the top left of the screen and select "Dirac Live". 3. Connect the supplied Speaker Setup microphone to the SETUP MIC jack on the main unit. Setup and to the left and right of the listening position; and "Full" which measures 9 positions including the listening position. Tap the method you prefer. "Quick": Set up the microphone at ear height in the listening position for measurement. Next measure by setting up the microphone between 50 and 100 cm away to the left and right of the listening position. "Full": Set up the microphone at ear height in the listening position for measurement. Next, measure in 8 positions to the front, back, left, right, etc., centered on the listening position. Measure by setting up the microphone in each of these positions, between 50 and 100 cm away from the listening position. Quick Full SETUP MIC 4. Tap "Next", confirm that the displayed speaker configuration is correct, then tap "Next". • If the setting in "System Setup" - "Speaker" - "Configuration" - "Speaker Channels" ( →p114) is different to the number of connected speaker channels, an error is displayed and measurement cannot be performed. 5. Select the method of measurement. There are two methods of measuring to choose from; "Quick" which measures 3 locations; at the listening position The illustration shows an image. 6. The guidance about outputting the test tone is displayed. Refer to the illustration to set up the speaker setup microphone in the listening position. Follow the on-screen instructions to measure. 154