Pioneer VSX-LX305 Instruction Manual English - Page 140
Network, IP Address Default Value: 0.0.0.0
View all Pioneer VSX-LX305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Network • When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each components, you must set "DHCP" to "Disable" and assign an address to this unit in "IP Address" as well as set information related to your LAN, such as Subnet Mask and Gateway. Wi-Fi (Default Value: Off(Wired)) Connect the unit to the network via a wireless LAN router. • When switching between "On" and "Off(Wired)", stop the Network service. Also, when group playback is in process, cancel the group playback once, and then switch the setting. On Off(Wired) Wireless LAN connection Wired LAN connection Wi-Fi Setup (Default Value: -) You can configure wireless LAN settings by pressing ENTER when "Start" is displayed. Wi-Fi Status (Default Value: -) The information of the connected access point will be displayed. SSID Signal Status SSID of the connected access point. Signal strength of the connected access point. Status of the connected access point. Setup MAC Address (Default Value: -) Check the MAC address of this unit. This value is specific to the component and cannot be changed. DHCP (Default Value: Enable) Enable Disable Auto configuration by DHCP Manual configuration without DHCP • If you select "Disable", you must set "IP Address", "Subnet Mask", "Gateway", and "DNS Server" manually. IP Address (Default Value: 0.0.0.0) Displays/Sets the IP address. Subnet Mask (Default Value: 0.0.0.0) Displays/Sets the subnet mask. Gateway (Default Value: 0.0.0.0) Displays/Sets the gateway. DNS Server (Default Value: 0.0.0.0) Displays/Sets the primary DNS server. 140