Pioneer VSX-LX505 ELITE 9.2 Channel AV Receiver Instruction Manual English - Page 110
Playing Back (ZONE 3), When outputting from the integrated amplifier
View all Pioneer VSX-LX505 ELITE 9.2 Channel AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Playing Back (ZONE 3) 2 1 Playback In the remote controller operation, while pressing and holding the ZONE 3 SHIFT button on the remote controller, operate with each button. Settings are required to playback a source in ZONE 3. When outputting from the speakers: Set "Speaker" - "Configuration" - "Zone Speaker" ( →p133) in the System Setup menu to "Zone 2/Zone 3". When outputting from the integrated amplifier: Set "Speaker" "Configuration" ( →p132) in the System Setup to one of the following. -- Set "Speaker Channels" to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch" -- Set "Speaker Channels" to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or "5.1.2 ch", and set "Bi-Amp" and "Zone Speaker" to "No" 1. Point the remote controller at the unit, and while pressing and holding the ZONE 3 SHIFT button on the remote controller, press . • "Z3" on the display of the main unit lights up. 2. While pressing and holding the ZONE 3 SHIFT button on the remote controller, press the input selector of the input source you want to play in the separate room. When operating on the main unit, press the ZONE CONTROL button repeatedly to select "Z3" on the display, then within 8 seconds select the input you want to play in another room using the input selector dial. 3. If the unit is connected to the integrated amplifier in the separate room, adjust the volume on the integrated amplifier. If the unit is connected to the power amplifier or ZONE speaker in the separate room, adjust the volume with the volume button while pressing and holding the ZONE 3 SHIFT button on the remote controller. When operating on the main unit, press the ZONE CONTROL button repeatedly to select "Z3" on the display, then within 8 seconds adjust using the MASTER VOLUME knob. • When connecting the power amplifier, set "Multi Zone" - "Zone 3" - "Output Level" ( →p149) to "Variable" on the System Setup menu. If it is not set, a large volume is output and the power amplifier, speakers, etc. may be damaged. • If you turn the unit to standby during multi-zone playback, the Z3 indicator is dimmed, and the playback mode is switched to playback in a separate room 110