Polk Audio SurroundBar 2000 SurroundBar 2000 Instant Home Theater Owner's Manu - Page 3
Inside Your SurroundBar, IHT Carton, Specifications, Remote Control - polk
View all Polk Audio SurroundBar 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
19. Replacement Parts. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that the parts have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. CAUTION: Danger of EXPLOSION if battery is incorrectly replaced. Replace only with the same or equivalent type. (CR2025) WARNING: Do not expose batteries or battery pack to excessive heat such as sunshine, fire or the like. 20. Safety Check. Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the products are in proper operating condition. 21. Carts and Stands. The appliances should be used only with a cart or stand that is recommended by the manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. Use caution when moving the cart/apparatus combination to avoid injury from tip-over. 22. This product is not intended for use outdoors. The CAUTION marks shown here are located on the back of your SurroundBar® Speaker System CAUTION: To prevent electric shock, match wide blade of plug to wide slot, insert fully. CAUTION: No naked flame sources, such as candles, should be placed on the apparatus. Radiation Exposure Statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. Operation This equipment complies with Part 15 of the FCC Rules and Industry Canada RSS-210. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) This device must accept any interference, including interference that may cause undesired operation of the device. Class B Emissions Limits This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Product Disposal Certain international, national and/or local laws and/ or regulations may apply regarding the disposal of this product. For further detailed information, please contact the retailer where you purchased this product or the Polk Importer/Distributor in your country. A listing of Polk Importer/ Distributors can be found on the Polk website: www.polkaudio.com or by contacting Polk at: 5601 Metro Drive, Baltimore, Maryland 21215, USA. Phone: 1-410-358-3600; in California: 1-800-377-7655. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. • The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. • Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Inside Your SurroundBar 2000 IHT Carton: Important Note: If anything is missing or damaged, or if your Polk SurroundBar 2000 IHT fails to operate, please notify your dealer immediately. We recommend keeping your original carton and packing materials in case you need to ship the unit in the future. SurroundBar Remote Control (Battery Included) 6' Digital (Optical) Cable Quick Start Guide Owner's Manual Online Registration Card Specifications Dimensions 3 3/4" H x 31" W x 2 1/2" D (9.53 cm x 78.74 cm x 6.35 cm) Weight 4 lbs 14 oz (1.88 kg) Power Requirements 20 V, 2.7 A Model SurroundBar 2000 Instant Home Theater Remote Battery CR2025 20V Power Supply Remote Control Power Source 1 Volume SOURCE VOL BASS Mute Source 2 Bass Volume 4 Polk Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600) Customer Service Hours of Operation: Monday-Friday, 9am-5:30pm est [email protected] 5