Poulan 1600 User Manual - Page 5
AWARNINGS, SAFETY, INSTRUCTIONS, continued
View all Poulan 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
AWARNINGS AND SAFETY INSTRUCTIONS----(continued) A OPERATOR SAFETY 1. Always wear a safety face shield or goggles. See "Accessories." 2. Always wear heavy, long pants, boots and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair so it is above shoulder length. 3. Do not operate this tool when you are tired, ill or under the influence of alcohol, drugs or medication. 4. Always use the assist handle. See "Assembly." 5. Wear hearing protection if you use this tool for more than 112/ hours per day. 6. Never start or run the engine inside a closed room or building. Breathing exhaust fumes can kill. 7. Keep handles free of oil and fuel. A TOOL SAFETY 1. Inspect the entire tool before each use. Replace damaged parts. Check for fuel leaks and make sure all fasteners are in place and securely fastened. 2. Replace trimmer head parts that are cracked, chipped or damaged in any way before using the tool. 3. Use only WEED EATER® flexible, non-metallic, monofilament cutting line of the correct diameter. Never use wire, rope, string, etc. 4. Be sure the shield is properly attached. 5. Use only the specified WEED EATER° trimmer head. See - Specifications." Make sure the trimmer head is properly installed and fastened. See "Assembly." 6. Be sure the trimmer head stops turning when engine idles. See "Carburetor Adjustments." 7. Makecarburetoradjustments with thedriveshaft housingsupported to prevent thetrimmerline from contacting any object. Hold the tool by hand. Do not use the optional shoulder strap for support. 8. Keep othersawaywhen makingcarburetoradjustments. 9. Use only WEED EATER° accessories as recommended for this tool by the manufacturer. A FUELSAFETY 1. Mix and pour fuel outdoors and where there are no sparks or flames. 2. Use a container approved for fuel. 3. Do not smokeor allow smoking near fuel or the tool or while using the tool. 4. Wipe up all fuel spills before starting engine. 5. Move at least 10 feet away from fueling site before starting engine. 6. Stop engine before removing fuel cap. 7. Empty the fuel tank before storingthe tool. It is recommended that the fuel be emptied after each use. If fuel is left in the tank, store so fuel will not leak. 8. Store tool and fuel in an area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. A CUTTINGSAFETY 1. Inspect the area to be cut before each use. Remove objects (rocks, broken glass, nails, wire, string, etc.) which can be thrown or become entangled in the trimmer head. 2. Keep others including children, animals, bystanders and helpers outside the 60 foot Hazard Zone. Stop the engine immediately if you are approached. 3. Always keep the engine on the right side ofyour body. 4. Hold the tool firmly with both hands. 5. Keep firm footing and balance. Do not over-reach. 6_ Keep the trimmer head below waist level. 7. Do not raise the engine above your waist. The trimmer head can come dangerously close to your body. 8. Keepall partsofyour bodyaway from thetrimmer head and muffler when the engine is running. 9. Use only for jobs explained in this manual. A MAINTENANCESAFETY 1. Maintain the tool according to recommended procedures. Keep the trimmer line at the proper length. 2. Disconnect the spark plug before performing maintenance except for carburetor adjustments. 3. Make carburetor adjustments with the drive shaft housingsupported to prevent the trimmer linefromcontacting any object. Hold the tool by hand. Do not use the optional shoulder strap for support. 4. Keepothersaway when makingcarburetoradjustments. 5. Use only genuine, WEED EATER° replacement parts as recommended by the manufacturer. A TRANSPORTINGANDSTORAGE 1. Hand carry the tool with the engine stopped, and the muffler away from your body. 2. Allow the engine to cool, empty the fuel tank, and secure the tool before storing or transporting in a vehicle. 3. Empty the fuel tank before storing the tool . It is recommended that the fuel be emptied after each use. If fuel is left in the tank, store so fuel will not leak. 4. Storesothelinelimiter cannotaccidentallycauseinjury. The tool can be hung by the bracket below the engine or by the drive shaft housing. 5. Store tool out of reach of children. Ifsituationsoccurwhichare notcoveredin thismanual, usecareandgoodjudgement. Contactyourdeakrifyou need assistance. 5