Poulan PRLM21i Owner Manual - Page 12
Transportation And Storage
View all Poulan PRLM21i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
LED screen Possible faults Product stops operating and all four battery capacity LED's flash, no other LEDs come on. Battery pack is loose in the powerhead and no longer makes good contact, battery pack is too warm, or cold or other internal battery error Possible steps 1. Stop the product. 2. Remove battery pack from product and press the indicator button on the battery pack to show the error code. The LED's on the battery pack come on and show an error code. 3. Read the included battery manual for a list of related LED error codes for possible faults and procedures. Product stops operating and the power button flashes while the battery capacity LED's continue to show the current state of charge If the battery pack does not show an error after pressing the indicator button on the battery pack and only displays the state of charge, the battery pack may have come loose in the powerhead during operation. Install the battery pack correctly into the powerhead until a click is heard. Cutting chamber is clog- 1. Stop the product. ged with grass, motor 2. Remove the battery pack and turn the controller is too warm, or product on its side with the user control in- motor fault terface pointing up. 3. Examine the blade, blade bolt, blade assembly, motor and motor base for damage. Clear all grass from the bottom of the ma- chine and examine for clogs. 4. Install the battery pack and follow the starting procedure to start the machine. If the error continues to show, let the product cool down. The motor controller may be too warm for operation. If the error continues to show, speak to an approved service center. TRANSPORTATION AND STORAGE • Keep equipment safe during transportation to prevent damage and accidents. • For storage, keep equipment in a locked area away from children and persons that are not approved. • For storage, keep the product and equipment in a dry and frost-proof area. • When loading or moving the product, do not go more than the maximum recommended operation angle of 15 degrees. • Clean the product. For more information, see To clean the product on page 10 . • Lubricate the product. • Tighten bolts and nuts. • Replace or repair damaged components. • Touch up all rusted or damaged paint surfaces. Sand lightly before painting. • Use the correct protective cover on the product that does not keep moisture. Do not use plastic because it cannot breathe, lets condensation collect and causes corrosion on the product. • Always remove the battery pack prior to transportation or storage. 12 355 - 002 - 03.10.2017