Poulan PRST15i Owner Manual - Page 12

LED screen Possible faults Possible steps LED 1 is red and LED 4 is Internal fuse is blown green, battery pack does not charge or operate correctly in product Speak to an approved service center. LED 1 is red Irregular cell voltage Speak to an approved service center. LED 4 is green Battery pack is overcharged Remove the battery pack from the battery charger and install in the product. Operate the product. Battery charger may be defective. Speak to an approved service center. LED 1 is red and LED 2 is Battery pack failure green, battery pack does not charge or operate correctly in product Remove battery pack from the product. Do not charge. Battery pack is damaged and must be replaced. Speak to an approved service center. RED LED comes on, LED 2 is green and flashes during charging or when the battery pack is in the battery charger Internal battery tempature is too low or too high for charging Move the battery charger and battery pack to a location where the internal temperature of the battery pack can be between 5°C (41°F) and 45°C (113°F). RED LED flashes and LED 2 Internal battery tempera- The internal temperature in the battery must be between flashes green when the bat- ture is too low or too -15°C (5°F) and 70°C (158°F). The environment tempera- tery pack is installed. high ture in the battery pack is too low or too high. • If the battery pack is too cold from the ambient environment, move the battery pack and battery charger to a warm environment. • If the battery pack is too hot, especially after operation, move the battery pack and battery charger away from the hot environment. TECHNICAL DATA Motor specifications Motor type Motor voltage Motor power Battery and charger specifications Default battery pack type Battery charger type Product dimensions Weight Cutting width unit V (DC) W kg (lb) cm (in) PRST15i (BLT58VPR) Brushless 58 750 PR140Li PR275Ci 3.4 (7.5) 38 (15) 12 316 - 002 - 20.11.2017