ProForm 1300 Zlt Treadmill Uk Manual - Page 10

7. Align the oval hole in the Left Upright Spacer (88) with the oval hole in the Base (95) as described in step 4. Hold a Bolt Spacer (14) inside the lower end of the Left Upright (84). Insert a 3/8" x 4 1/4" Patch Bolt (7) with a 3/8" Star Washer (11) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (14), 3/8" x 4 1/4" Patch Bolt (7), and 3/8" Star Washer (11). Hold the Left Upright Spacer (88) and the Left Upright (84) against the Base (95). Tighten the 3/8" x 4 1/4" Patch Bolts (7) until the heads of the Patch Bolts touch the Left Upright; do not fully tighten the Patch Bolts yet. With the help of a second person, tip the treadmill so that the Base (95) is flat on the floor. 7 7 11 14 95 84 88 8. Insert the bracket on the Left Handrail (82) into the Left Upright (84). Insert the Upright Wire (87) several inches downward into the Right Upright (85); make sure that the wire tie does not fall into the Right Upright. Then, insert the Right Handrail (83) into the Right Upright. Be careful not to pinch the Upright Wire. Orient the Console Frame (102) as shown, with the welded nuts on the bottom. Insert the ends of the Console Frame into the Left and Right Handrails (82, 83). Attach the Console Frame with four 1/4" x 1 1/4" Patch Bolts (9) and four 1/4" Star Washers (12). Start all four Patch Bolts, and then tighten them. Lift the Console Frame (102) and the Handrails (82, 83) off the Uprights (84, 85). Then, pull the Upright Wire (87) out of the Right Upright. 8 9 12 82 102 Welded Nuts Bracket 9 84 12 83 87 Wire Tie Welded Nuts 85 10