ProForm 19.0 Re Elliptical English Manual - Page 10
Tip: To prevent the Main Wire Harness 60
View all ProForm 19.0 Re Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3. Orient the Front Stabilizer (3) so that the small welded tubes are facing away from the Main 3 Frame (1). Attach the Front Stabilizer (3) to the Main Frame (1) with two M10 x 95mm Screws (100). Welded Tubes 100 3 1 4. Orient the Upright (5) and the Top Cover (27) as shown, and slide the Top Cover upward onto the Upright. Have a second person hold the Upright (5) and the Top Cover (27) near the Main Frame (1). Locate the wire tie in the Upright (5). Tie the lower end of the wire tie to the Main Wire Harness (60). Next, pull the upper end of the wire tie until the Main Wire Harness is routed through the Upright. Tip: To prevent the Main Wire Harness (60) from falling into the Upright (5), secure the Main Wire Harness with the wire tie. Tip: Avoid pinching the Main Wire Harness (60). Slide the Upright (5) onto the Main Frame (1). Attach the Upright (5) with four M8 x 16mm Screws (102) and four M8 Split Washers (103); do not tighten the Screws yet. Slide the Top Cover (27) downward; do not press the Top Cover onto the Frame Covers (21, 22) yet. 4 Wire Tie Avoid pinching the Main Wire Harness (60) 5 102 103 102 27 22 102 103 Wire Tie 60 1 21 10