ProForm 19.0 Re Elliptical English Manual - Page 11
Tip: Avoid damaging the Main Wire Harness
View all ProForm 19.0 Re Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5. Using a plastic bag to keep your fingers clean, apply a generous amount of the included grease to the Upright Axle (48) and to two Wave Washers (118). Tip: Avoid damaging the Main Wire Harness (60). Insert the Upright Axle (48) through the Upright (5) and center it. Slide a Wave Washer (118) onto each side of the Upright Axle. Next, identify the Right and Left Upper Body Legs (6, 7) and orient them as shown. Slide the Right and Left Upper Body Legs (6, 7) onto the right and left sides of the Upright Axle (48). Tighten an M8 x 16mm Screw (102) and an M8 Washer (95) into each end of the Upright Axle (48) at the same time. 5 60 102 95 118 7 5 Avoid damaging the Main Wire Harness (60) Grease 48 118 95 102 6 6. Identify the Right Pedal (14) and the Right Pedal Arm (12) and orient them as shown. 6 Attach the Right Pedal (14) to the Right Pedal Arm (12) with five M6 x 12mm Screws (111). Attach the Left Pedal (not shown) to the Left Pedal Arm (not shown) in the same way. 14 12 111 111 11