ProForm 490 C Treadmill English Manual - Page 12

12. Raise the Frame (51) to the position shown. Have a second person hold the Frame until 12 this step is completed. Orient the Storage Latch (48) so that the large barrel and the Latch Knob (49) are in the positions shown. Attach the lower end of the Storage Latch to the bracket on the Base (86) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Attach the upper end of the Storage Latch (48) to the bracket on the Frame (51) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Note: It may be necessary to move the Frame back and forth to align the Storage Latch with the bracket. Lower the Frame (51) (see HOW TO LOWER THE TREADMILL FOR USE on page 21). 51 8 4 48 49 Large Barrel 86 8 4 13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 4.2 x 16mm Screw (3) 96 and the Access Door (105) from the Console Base (96). 2. Connect the wire on the receiver to the indicated wire extending from the Console Base (96). Hold the receiver so the antenna is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (105) with the two included small screws. Small Screws Wire Receiver 3. Make sure that no wires are pinched. Reattach the Access Door (105) with the #8 x 3/4" Screw (12). Discard the other wires included with the receiver. Antenna 105 3 12