ProForm 515 Zlt English Manual - Page 11

9. With the help of a second person, hold the console assembly near the Right Handrail (64). See the inset drawing. Connect the Upright Wire (63) to the console wire. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. If YOU DO NOT CONNECT the connectors properly, the console may become damaged when you turn on the power. Then, remove the wire tie from the Upright Wire. Connect the Console Ground Wire (47) on the Console Crossbar (61) to the ground wire on the console. 9 Console Assembly Console Wire 63 64 Ground Wire 47 61 Wire Tie Console Wire 63 10. Set the console assembly on the Left and Right Handrails (59, 64). Make sure that no wires 10 are pinched. Cut and remove the tie (D). Console Assembly Attach the console assembly with four #8 x 3/4" Screws (4). Start all four Screws, and then tighten them. Do not overtighten the Screws. Insert the wires into the Right Handrail (64) through the indicated hole. See assembly step 5. Firmly tighten the six 3/8" x 3 1/4" Screws (2) on the lower ends of the Left and Right Uprights (66, 76) (only one side is shown). 64 Wires Hole 4D 76 Ground Wires 59 4 66 11