ProForm 590hr Treadmill User Manual - Page 7

2. Open part bag C. See drawing 2a. Attach a Wheel (108) to each Wheel Housing (106) with a Wheel Bolt (107) and a Wheel Nut (21) as shown. Do not overtighten the Wheel Bolts. See drawing 2b. Insert a Wheel Housing (106) into the Base (109). (Note: It may be helpful to use a rubber mallet to fully insert the Wheel Housing.) Next, press a Base Endcap (99) into the Base. Repeat this step on the opposite side of the treadmill. 2a 106 107 108 2b 106 21 107 108 99 109 106 3. With the help of a second person, carefully tip the Uprights (69, 82) down so the treadmill pivots on the Wheels (108) as shown. Tighten a 3/4" Screw (6) into one side of the Base (109) and one of the Wheel Housings (106). Attach a long Rear Base Pad (105) and a short Front Base Pad (100) to the Base with four additional 3/4" Screws (6) as shown. Repeat this step on the opposite side of the treadmill. With the help of a second person, carefully raise the Uprights (69, 82) to the vertical position. 3 69 82 100 6 6 100 109 105 109 106 6 108 6 105 6 106 108 4. Open part bag A. With the help of a second person, 4 hold the Console Base (85) near the Uprights (69, 82) as shown. Connect the Wire Harness (83) to the wire harness in 71 the Right Handrail Bracket (113). Make sure to connect 72 the connectors properly (see the inset drawing). The connectors should slide together easily and snap 73 into place. If the connectors do not slide together easily 85 and snap into place, turn one connector and try to con- nect them again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE 69 71 DAMAGED WHEN THE POWER IS TURNED ON. 72 Insert the wires harnesses into the Right Upright (82). 83 Hold the Handrail Brackets (73, 113) on top of the Uprights (69, 82). Finger tighten two 1" Bolts (71) with Internal Star Washers (72) into the Handrail Brackets and the tops of the Uprights as shown. Press the Handrail Brackets towards the centre of the treadmill. Then, tighten both Bolts. 113 82 83 7