ProForm 600 Zlt Treadmill Uk Manual - Page 13

13. Slide the Right Upright Cover (110) up against the Right Handrail (101). Attach the Right 13 Upright Cover with two M4 x 16mm Screws (124). Be careful not to overtighten the Screws. Attach the Left Upright Cover (not shown) as described above. See steps 5 and 7. Tighten the two M10 x 95mm Patch Bolts (8) and the two M10 x 68mm Patch Bolts (114). 101 110 124 14. Raise the Frame (56) to the position shown. Have a second person hold the Frame until this step is completed. Orient the Storage Latch (60) so that the large barrel and the latch knob are in the positions shown. Attach the upper end of the Storage Latch (60) to the Frame (56) with a 3/8" x 1 3/4" Patch Bolt (7) and a 3/8" Locknut (6). Attach the lower end of the Storage Latch (60) to the Base (95) with two 3/8" x 2" Bolts (37) and two 3/8" Locknuts (6). Note: It may be necessary to move the Frame (56) back and forth to align the Storage Latch with the Base. Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on page 24). 14 56 6 7 Latch Knob Large Barrel 60 95 6 37 15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 26 and 27). 13