ProForm 635 Uk Manual - Page 7

move the left Rear Foot. Snap the Rear Foot Spacer

Page 7 highlights

4. Insert a Handrail Extension (85) into the post on the left Upright (82). If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Align the holes in the Handrail Extension with the holes in the post. Next, attach the Handrail Extension by tightening three Short Screws (76) into the indicated holes. Note that the hole in the left side of the post is not used. Note: If there is only one hole in the top of the post, tighten the third Short Screw into the hole in the left side of the post. Identify the Left Handgrip (122), which has a large cutout in the right side. Slide the Left Handgrip as far as possible onto the Handrail Extension (85). It may be helpful to apply soapy water to the Handrail Extension. 5. Make sure that the front edge of the Left Handgrip (122) is under the Console Base (87) as shown. Tighten a Short Screw (76) into the side of the Left Handgrip as shown. Attach the other Handrail Extension (not shown) and the Right Handgrip (not shown) as described in step 4 and this step. Note: When assembly is completed, there may be extra screws left over. 4 122 76 Post 85 Cutout 76 82 76 5 87 76 122 76 6. Refer to drawing 6a. Locate the left Rear Foot (59) on 6a the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left Rear Foot and the floor, follow the instructions below. Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 22. 59 Refer to drawing 6b. Using a phillips screwdriver, remove the Rear Foot Screw (60), the right Rear Foot (59), and 6b the Rear Foot Spacer (120) from the treadmill. Reattach the right Rear Foot without the Rear Foot Spacer. Hold the treadmill with both hands, and lower the treadmill as described on page 22. Check the left Rear Foot (59 [see drawing 6a]). If the left Rear Foot is still off the floor, raise the treadmill and remove the left Rear Foot. Snap the Rear Foot Spacer (120) onto the left Rear Foot and reattach the left Rear Foot and the Rear Foot Spacer. Carefully lower the treadmill. 60 59 120 7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from damage, place a mat under the treadmill. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30

7
7.
Make sure that all parts are tightened before you use the treadmill.
Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
5
5.
Make sure that the front edge of the Left Handgrip (122)
is under the Console Base (87) as shown. Tighten a
Short Screw (76) into the side of the Left Handgrip as
shown.
Attach the other Handrail Extension (not shown) and the
Right Handgrip (not shown) as described in step 4 and
this step.
Note: When assembly is completed, there may be
extra screws left over.
76
122
87
6.
Refer to drawing 6a. Locate the
left
Rear Foot (59) on
the treadmill. If the left Rear Foot touches the floor, go to
step 7. If there is a space between the left Rear Foot and
the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page 22.
Refer to drawing 6b. Using a phillips screwdriver, remove
the Rear Foot Screw (60), the
right
Rear Foot (59), and
the Rear Foot Spacer (120) from the treadmill. Reattach
the right Rear Foot without the Rear Foot Spacer. Hold
the treadmill with both hands, and lower the treadmill as
described on page 22.
Check the
left
Rear Foot (59 [see drawing 6a]). If the left
Rear Foot is still off the floor, raise the treadmill and re-
move the left Rear Foot. Snap the Rear Foot Spacer
(120) onto the left Rear Foot and reattach the left Rear
Foot and the Rear Foot Spacer. Carefully lower the
treadmill.
59
120
60
6a
6b
59
4.
Insert a Handrail Extension (85) into the post on the left
Upright (82). If necessary, tap the Handrail Extension
with a rubber mallet to fully insert it. Align the holes in the
Handrail Extension with the holes in the post. Next, at-
tach the Handrail Extension by tightening
three
Short
Screws (76) into the indicated holes. Note that the hole in
the left side of the post is not used.
Note: If there is only
one hole in the top of the post, tighten the third Short
Screw into the hole in the left side of the post.
Identify the Left Handgrip (122), which has a
large
cutout
in the right side. Slide the Left Handgrip as far as possi-
ble onto the Handrail Extension (85). It may be helpful to
apply soapy water to the Handrail Extension.
76
82
122
Cutout
76
Post
85
4
76
76