ProForm 696 Elliptical Uk Manual - Page 11

12. The Console (5) can be operated with four 1.5V "D" batteries; alkaline batteries are recommended. IMPORTANT: If the elliptical exerciser has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Press the tab on the battery cover, and remove the battery cover. Next, insert four batteries into the Console. Make sure that the batteries are oriented as shown by the diagrams inside the battery compartment. Then, reattach the battery cover to the Console. Note: The Console (5) can also be operated with an optional power supply instead of batteries. To purchase a power supply, call the telephone number on the front cover of this manual. Plug one end of the power supply into the jack on the Console. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 12 Batteries 5 13. Tip: Be careful not to pinch the wire har- 13 nesses during this step. While another person holds the Console (5) near the Upright (3), con- nect the wire harness on the Console to the Upper Wire Harness (48). Insert the excess wire harness into the Upright. Next, attach the Console to the Upright with four M4 x 16mm Round Head Screws (101). Batteries Battery Cover Avoid pinching the wire harnesses 5 during this step Console Wire 48 3 101 14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 11