ProForm 760 Hr Bike Uk Manual - Page 7
the Seat Post 8 into the Frame. Release the Knob
View all ProForm 760 Hr Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Attach the Handlebar Bracket (6) to the Upright (2) with two M8 x 39mm Button Bolts (52), two M8 Nylon 5 Locknuts (49), and an M8 x 14mm Button Screw (75). 49 75 6 2 6. Hold the Console (4) near the Upright (2). Connect the console wire to the Upper Wire Harness (42). Insert the excess wire down into the Upright. Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (57). Be careful to avoid pinching the wires. 7. Turn the indicated Adjustment Knob (20) counterclockwise two or three turns to loosen it. Next, pull the Knob, remove the packing tube from the Frame (1), and insert the Seat Post (8) into the Frame. Release the Knob, and move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwise until it is tight. Slide the Seat Carriage (11) onto the Seat Bracket (7), and then tighten the Seat Knob (10) into the right side of the Seat Carriage. Tighten the M6 x 8mm Zinc Button Screw (71) into the Seat Bracket behind the Seat Carriage. Loosen the two nuts (not shown) on the clamp beneath the Seat (9). Slide the clamp fully onto the Seat Carriage (11). Tilt the Seat to the desired angle, and then retighten the nuts on the clamp. 52 6 4 57 7 Console 42 Wire 2 9 Nut 71 8 7 Nut 10 11 20 Packing Tube 1 7