ProForm 780 Zlt Treadmill Uk Manual - Page 11

11. Have a second person hold the console assembly near the Right Upright (79). Connect the Wire Harness (86) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Wire Harness. Insert the connectors and the excess wire into the Right Handrail (105). Set the console assembly on the Right Handrail (105) and Left Handrail (not shown). Be careful not to pinch the wires. 11 Console Assembly Console Wire 105 86 Console Wire Tie Wire 86 79 12. Be careful not to pinch the wires in the Right Handrail (105). Attach the console assembly to the Right Handrail (105) with two #8 x 3/4" Screws (1) and a 1/4" x 1 1/4" Bolt (6) with a 1/4" Star Washer (10). Repeat this step on the left side of the console assembly. Start all four Screws and both Bolts before tightening any of them. See steps 5 and 7-10. Tighten all of the bolts used in these assembly steps. 12 Console Assembly 105 1 10 6 11