ProForm 890 E Elliptical English Manual - Page 7

3. Identify and orient the Upright (5) and the Top Cover (27) as shown. 3 Slide the Top Cover (27) upward onto the Upright (5). Then, have a second person hold the Upright (5) and the Top Cover (27) near the Main Frame (1). Locate the wire tie in the Upright (5). Tie the lower end of the wire tie to the Wire Harness (60). Next, pull the upper end of the wire tie until the Wire Harness is routed completely through the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness (60) from falling into the Upright (5), secure the Wire Harness with a rubber band or tape. Tip: Avoid pinching the Wire Harness (60). Insert the Upright (5) into the Main Frame (1). Attach the Upright (5) with four M8 x 16mm Patch Screws (102) and four M8 Split Washers (103); do not tighten the Patch Screws yet. Wire Tie Avoid pinching the Wire Harness (60) 5 27 Wire Tie 60 102 103 102 103 1 102 103 102 7