ProForm 940s English Manual - Page 13
two M6 Stop
View all ProForm 940s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
HOW TO ADJUST THE BELT The exercise cycle features a precision belt that must be kept properly adjusted. If the belt causes exces- sive noise or slips as you pedal, the belt should be checked. To do this, the left side shield must first be removed. Refer to the instructions on page 12 and remove the left side shield. Next, use an adjustable 16 wrench to turn the right pedal counterclock- wise and remove it. Remove the right side shield. Press down on the center of the Belt (16) between the front and rear sprockets. There should be from 1/4Ó to 3/4Ó of vertical movement in the center of the Belt. If the Belt (16) is properly adjusted, reattach the side shields and pedals. If the Belt needs to be adjusted, loosen the M8 Washer Nut (37) on each side of the Flywheel (32). To tighten the Belt, turn the two M6 Stop 16 nuts (47) clock- wise; to loosen the belt, turn 32 the Nuts coun- terclockwise. Make sure that 37 the Flywheel is 47 straight and tighten the M8 Washer Nuts (37). Reattach the side shields and pedals. 13