ProForm Crosstrainer 970 English Manual - Page 8

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR, Make sure that no, wires are pinched.

Get ProForm Crosstrainer 970 PDF manuals and user guides View all ProForm Crosstrainer 970 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (refer to page 20), follow the steps below to install the receiver and the jumper wire included with the chest pulse sensor. 1. Remove the four indicated screws from the back of the Console (16). Lift off the front of the Console. 1 16 Lift Here Screws 2. Plug the jumper wire (A) into the indicated jack on the Console (16). Connect the other end of the jumper wire 2 to the wire on the receiver (B). 16 Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and press it onto the Console (16) in the indicated location. Refer to step 1 above. Reattach the front of the Console (16) with the four screws. Make sure that no wires are pinched. B Cylinder Jack A 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to page 20), follow the steps below to install the receiver
and the jumper wire included with the chest pulse sensor.
1.
Remove the four indicated screws from the back of the
Console (16). Lift off the front of the Console.
2.
Plug the jumper wire (A) into the indicated jack on the
Console (16). Connect the other end of the jumper wire
to the wire on the receiver (B).
Next, peel the paper off the adhesive pad on the back
of the receiver (B). Orient the receiver as shown, and
press it onto the Console (16) in the indicated location.
Refer to step 1 above. Reattach the front of the
Console (16) with the four screws.
Make sure that no
wires are pinched.
8
B
16
Jack
16
Screws
Lift
Here
1
A
Cylinder
2