ProForm I Series 785 F Elliptical User Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included tool(s), assembly requires a Phillips screwdriver wrench , and a rubber mallet . , an adjustable As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. M8 Split Washer (83)-9 16mm Wave Washer (54)-2 19mm Wave Washer (66)-4 M10 Washer (95)-2 M8 x 25mm Washer (98)-6 M8 Locknut (102)-8 M10 Locknut (92)-2 M4 x 16mm M8 x 19mm Patch Screw (104)-10 Screw (82)-15 M8 x 38mm Bolt (96)-8 M8 x 80mm Patch Screw (84)-2 M10 x 45mm Patch Screw (99)-4 M10 x 60mm Bolt (100)-2 5