ProForm I Series 785 F Elliptical User Manual - Page 8

6. Identify the Right Upper Body Arm (61) and the Right Upper Body Leg (60), which are marked 6 with "Right" stickers, and orient them as shown. Make sure that the hexagonal holes are in the indicated location. Slide the Right Upper Body Arm (61) onto the Right Upper Body Leg (60). Attach the Right Upper Body Arm (61) with two M8 x 38mm Bolts (96) and two M8 Locknuts (102). Make sure that the Locknuts are in the hexagonal holes. Repeat this step for the Left Upper Body Arm (not shown) and the Left Upper Body Leg (not shown). 61 102 Hexagonal Holes 96 60 7. Apply a small amount of grease to the Pivot Axle (35) and to a 16mm Wave Washer (54). 7 Insert the Pivot Axle (35) through the Upright (4) and then center it. Slide the 16mm Wave Washer (54), an Inner Leg Cover (68), and the Right Upper Body Leg (60) onto the right side of the Pivot Axle (35). Repeat this step for the Left Upper Body Leg (not shown). Tighten an M8 x 19mm Patch Screw (82) and an M8 x 25mm Washer (98) into each end of the Pivot Axle (35). 4 Grease 35 54 68 60 98 82 8