ProForm Pfevex92407 Instruction Manual - Page 6

Tip: Avoid pinching the Wire Harnesses 31, 32

Get ProForm Pfevex92407 PDF manuals and user guides View all ProForm Pfevex92407 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

1. To make assembly easier, read the 1 information on page 5 before you begin assembling the exercise cycle. Identify the Front Stabilizer (2), which has round wheels. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 73mm Button Screws (33) and two M10 Split Washers (34). 1 2 34 34 33 2. While another person lifts the rear of the Frame (1), 2 attach the Rear Stabilizer (14) to the Frame with two M10 x 73mm Button Screws (33) and two M10 Split Washers (34). 14 1 34 34 33 3. While another person holds the Upright (3) near the Frame (1), connect the Upper Wire Harness (32) to the Lower Wire Harness (31). Gently pull the upper end of the Upper Wire Harness (32) to remove the slack, and slide the Upright (3) onto the Frame (1). Tip: Avoid pinching the Wire Harnesses (31, 32) during this step. Attach the Upright (3) with three M10 x 20mm Button Screws (35) and three M10 Bright Split Washers (69). 3 3 Avoid pinching the Wire Harnesses (31, 32) during this step 69 35 35 69 32 31 1 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
6
2.
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (14) to the Frame with
two M10 x 73mm Button Screws (33) and two M10
Split Washers (34).
33
34
34
14
1
3
3
35
Avoid pinching the
Wire Harnesses (31, 32)
during this step
69
69
1
35
3.
While another person holds the Upright (3) near the
Frame (1), connect the Upper Wire Harness (32) to
the Lower Wire Harness (31).
Gently pull the upper end of the Upper Wire
Harness (32) to remove the slack, and slide the
Upright (3) onto the Frame (1).
Tip: Avoid pinching the Wire Harnesses (31, 32)
during this step.
Attach the Upright (3) with three
M10 x 20mm Button Screws (35) and three M10
Bright Split Washers (69).
2
32
31
1.
Identify the Front Stabilizer (2), which has round
wheels. While another person lifts the front of the
Frame (1), attach the Front Stabilizer to the Frame
with two M10 x 73mm Button Screws (33) and two
M10 Split Washers (34).
2
33
34
34
1
1
To make assembly easier, read the
information on page 5 before you begin
assembling the exercise cycle.