ProForm Power 1295i Instruction Manual - Page 34

SYMPTOM: The walking belt is not centered between the foot rails a. IMPORTANT: If the walking belt rubs against the foot rails, the walking belt may become damaged.First, remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is centered. SYMPTOM: The tablet holder does not stay in place a. Rotate the tablet holder backwards. Then, tighten the indicated screw slightly until the tablet holder stays in place when it is rotated to the desired position. a Screw Tablet Holder a Foot Rails SYMPTOM: The walking belt slips when walked on a. First, remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. a SYMPTOM: The iFit mode does not function correctly a. If the iFit mode is not functioning correctly, make sure that the treadmill has the most current firmware available (see step 3 on page 28). SYMPTOM: The incline of the treadmill does not change correctly a. Calibrate the incline system (see step 4 on page 29). SYMPTOM: The treadmill will not connect to the wireless network a. Make sure that the wireless settings on the console are correct (see page 29). b. Make sure that the settings for your wireless network are correct. c. If you still have questions, see the front cover of this manual. 34