ProForm Space Saver 695 Elliptical Uk Manual - Page 11

12. The Console (5) can use four D batteries (not included); alkaline batteries are recommended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic components. Remove the battery cover, insert the batteries into the battery compartment, and reattach the battery cover. Make sure to orient the batteries as shown by the diagram inside the battery compartment. To purchase an optional AC adapter, contact the store where you purchased this product or call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied AC adapter. Plug one end of the AC adapter into the jack on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. 12 Batteries 5 Batteries Battery Cover 13. While another person holds the Console (5) near the Upright (3), connect the wire harness 13 on the Console to the Upper Wire Harness (48). Tip: Avoid pinching the wires. Insert the excess wire harness into the Upright (3). Attach the Console (5) to the Upright (3) with four M4 x 16mm Round Head Screws (101). 5 Avoid pinching the wires Console Wire 48 3 101 14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 11