ProForm Trainer 8.0 Instruction Manual - Page 12

May Become Damaged When You Turn

Get ProForm Trainer 8.0 PDF manuals and user guides View all ProForm Trainer 8.0 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

10. Insert the Upright Wire (81) through the indicated looped tie (I) on the console assembly (F). 10 See the inset drawing. Connect the Upright Wire (81) to the console wire (J). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Then, remove the wire tie from the Upright Wire. Pull the tie (I) tight around the Upright Wire (81) and cut off the end of the tie. F J I 81 11. T ighten two #8 x 1" Screws (50) into the bottom of the console assembly (F) in the location 11 shown. 12. Identify the Right and Left Trays (34, 36). 12 Attach the Trays (34, 36) to the Console Base (64) with eight #8 x 1/2" Screws (1); do not overtighten the Screws. F 50 34 36 1 12 64 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
12
10. Insert the Upright Wire (81) through the indicated
looped tie (I) on the console assembly (F).
See the inset drawing.
Connect the Upright
Wire (81) to the console wire (J).
The connec-
tors should slide together easily and snap
into place.
If they do not, turn one connector
and try again.
IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
Then, remove the wire tie
from the Upright Wire.
Pull the tie (I) tight around the Upright Wire (81)
and cut off the end of the tie.
10
I
J
F
81
11.
Tighten two #8 x 1" Screws (50) into the bot-
tom of the console assembly (F) in the location
shown.
11
50
F
12
64
34
36
1
1
12.
Identify the Right and Left Trays (34, 36).
Attach the Trays (34, 36) to the Console Base
(64) with eight #8 x 1/2" Screws (1);
do not
overtighten the Screws.