ProForm Trainer 8.0 Instruction Manual - Page 16
IMPORTANT: The Tablet Holder 105 is
View all ProForm Trainer 8.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
19. Firmly tighten the four 3/8" x 2 3/8" Screws (7) and the two 3/8" x 1 1/4" Screws (63). Next, tighten the two 3/8" x 1 3/4" Screws (62); the Wheels (97) must turn freely. Set the Left Inner Base Cover (108) onto the lower end of the Left Upright (89). Then, slide the Left Base Cover (82) downward and press it onto the Left Inner Base Cover. Next, set the Right Inner Base Cover (109) onto the lower end of the Right Upright (90). Then, slide the Right Base Cover (83) downward and press it onto the Right Inner Base Cover. 19 90 89 82 63 108 83 63 7 109 62 97 7 62 97 20. P ress the two tabs (not shown) on the Tablet Holder (105) into the slots (L) in the console assembly (F). Then, attach the Tablet Holder (105) with four #8 x 5/8" Machine Screws (26). Tip: Start the two upper Machine Screws first, and then start the two lower Machine Screws. Do not overtighten the Machine Screws. IMPORTANT: The Tablet Holder (105) is designed for use with most full-size tablets. Do not place any other electronic device or object in the Tablet Holder. 20 Start First 26 105 26 L F 21. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 27 and 28). Note: Extra parts may be included. 16