ProForm Xp 160 Elliptical English Manual - Page 11

12. The Console (5) requires four 1.5V "D" batteries 12 (not included); alkaline batteries are recommend- ed. IMPORTANT: If the ellipical exerciser has been exposed to cold temperatures, allow it to warm to room temperature before insert- ing batteries into the Console. If you do not do this, the console displays or other elec- tronic components may become damaged. See the inset drawing. Remove the battery cover 5 from the Console and insert four batteries into the Console. Make sure that the batteries are ori- ented as shown by the diagram in the battery compartment. Then, reattach the battery cover. Note: The Console (5) can be operated with an optional power supply instead of batteries. To purchase a power supply, call the toll-free telephone number on the front cover of this manual. Plug one end of the power supply into the jack on the console. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 79 Have a second person hold the Console (5) near the Upright (6) as shown. Connect the console wire to the Wire Harness (48). Insert the excess wire downward into the Upright. Attach the Console (5) to the Upright (6) with four M4 x 16mm Self-tapping Screws (79). Battery Cover 5 6 48 Console Wire 13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 11