ProForm Ze5 Rear Drive Elliptical English Manual - Page 5

ASSEMBLY To hire an authorized service technician to assemble the elliptical, call 1-800-445-2480. Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included tool(s), assembly requires a Phillips screwdriver mallet . and a rubber See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. To avoid damaging parts, do not use power tools for assembly. M8 Split Washer M10 Split (103)-10 Washer (123)-4 M8 x 23mm x 1.5mm Washer (126)-4 Small Wave Washer (118)-2 Medium Wave Washer (119)-2 M4 x 16mm Screw (93)-16 M4 x 19mm Flat Head Screw (117)-1 M6 x 12mm Patch Screw (111)-10 M8 x 16mm Patch Screw (102)-18 M10 x 80mm Patch Screw (100)-4 5