ProForm Ze5 Rear Drive Elliptical English Manual - Page 9

7. Apply grease to the axle on the Right Upper Body Leg (6) and to a Medium Wave Washer (119). Slide a Leg Spacer (55) and the Medium Wave Washer (119) onto the Right Upper Body Leg (6). Make sure that the flat side of the Leg Spacer is facing away from the elliptical. Identify the Right Pedal Arm (12), which is marked with a "Right" sticker, and orient it as shown. Slide the Right Pedal Arm onto the Right Upper Body Leg (6). Attach the Right Pedal Arm (12) with an M8 x 16mm Patch Screw (102), an Axle Cover (56), and an M8 x 23mm x 1.5mm Washer (126). Repeat this step on the other side of the elliptical. 7 12 6 Grease 55 119 126 56 102 8. Press the Right Pedal Arm (12) onto the right 8 Adjustment Sleeve (46). Make sure that the Right Pedal Arm latches into place. Attach a Mounting Block (116) to the right Adjustment Pin (44) with an M6 x 12mm Patch Screw (111). Repeat this step on the other side of the elliptical. 12 116 46 111 44 9. Attach an Adjustment Knob (45) to the right 9 Mounting Block (116) with two M4 x 16mm Screws (93). Repeat this step on the other side of the elliptical. 9 93 116 45 93