Pyle PETW102 Installation Guide - Page 6

For correct installing, make sure that hook of every bracket must facing down. Use selected bolts, spacers and washers for installing bracket at the back of display. Adjust two brackets to equal heights and level. Once aligned, tightly secure the bolts. IMPORTANT: Don't force the bolt into the hole, which will cause a damage of equipments and injure of person. Don't use electric drill to fasten any bolts. Following examples shows how to use bolts, spacers and square washers. 1.Some displays have vertical backs. No spacer is required. Install the bracket directly to the back of display by using bolts and washers provided. As shown in Fig.1a. M4 Fig bit M5 Fig bit GA 2 2 GB 2. Some displays have curved backs with recessed mounting lands(Fig.a). It will require the use of spacer. For this display, install a 9/16" spacer(N) between display and the bracket. As shown in Fig 1b. M4 Fig bit N D 2 G Fig a M5 Fig bit N 2 GE 2 M6 Fig bit HC Fig 4a -6- M6 Fig bit 2 N HF Fig 4b -7-