Pyle PLAD214 PLAD213 Manual 1 - Page 10
Pyle PLAD214 Manual
View all Pyle PLAD214 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
FERTURES € CONTROLS 11. B- TERMINAL (CHASSIS GROUND) To avoid unwanted ignition noise caused by ground loops, it is essential that the Amplifier be grounded to a clean, bare, metal surface of the vehicles chassis. 12. REMOTE POWER ON To remote wire car stereo. This amplifier is turned "ON" remotely when vehicle's stereo is turned "ON". Note: IF YOUR RADIO DOES NOT HAVE +12 VOLT OUTPUT LEAD WHEN TURNED ON, THE "REMOTE" TERMINAL ON THE AMPLIFIER CAN BE CONNECTED TO VEHICLES ACCESSORY CIRCUIT WHICH PROVIDES +12V WHEN THE CAR IS ON. 13.B+ TERMINAL (BATTERY POSITIVE) Due to the power requirements of the Amplifier, this connection should be made directly to the positive(+) terminal of battery. For safety measure, install an in-line fuse Holder (not included) as close to the battery positive(+) terminal as possible with an ampere rating not to exceed total value of fuses in Amp. 14.SPEAKER TERMINAL LEVEL MIN O Remote Bass Level Control : Optional Remote Bass Boost Control : This control adjusts the Bass Boost gain for the amplifier's speaker output (0 - +12dB) 9