Pyle PLAD214 PLAD213 Manual 1 - Page 8

FERTURES € CONTROLS 1. Remote Control Input ( Pig-1 ) 2.Bass Boost Control -Bass Boost control - ON/OFF(PLAD212/213/214/215/412/413) By using the Bass Boost function, bass notes at 35Hz-80Hz are emphasized as much as 10dB - Variable Bass Boost(PLAD618) By using the Bass Boost function, bass notes at 45Hz are emphasized as much as 18dB. 3.Low Pass Filter When Crossover Mode Selector is in Low Pass Mode, this control limits the frequencies which will be distributed to the speakers to those below the value to which this is set within the range 40-350Hz. 4.Crossover Mode Switch Adjust the crossover for your chosen installation method. -LPF: Low pass filter- only bass tones (40Hz-350Hz)go to speakers. Use with woofer or sub-woofer. -FULL: No filter- all tones go to speakers. Use with full-range speakers, or with external crossovers_ -HPF: High pass filter-blocks very low tones(40Hz-3kHz)from the speakers. 5.High Pass Filter When Crossover Mode Selector is in High Pass Mode, this control limits the frequencies which will be distributed to the speakers to those above the value to this is set within the range 40Hz-3kHz. 6.Input Level Controls Enables the matching of input levels to the output levels from the head unit(or other signal source). 7.Line Input RCAJacks These inputs are for signal cables from the source. Always use high quality shielded RCA cables. 8. Line Out RCA Jacks The LINE OUT allows you to build multiple amplifier systems without having to use splitter cords to distribute the signal. Now it is simple a matter of bringing one set of RCAs into the first amplifier, then using the line out RCA jacks as the feed to the next amplifier. - 7 -