Pyle PLCDBT65MRW User Manual - Page 14

TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom No power. Cause The car ignition switch is not on. The fuse is blown. Solution If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to "ACC". Replace the fuse. Disc cannot be loaded or ejected. Presence of CD disc inside the player. Inserting the disc in reverse direction. Remove the disc in the player, then put a new one. Insert the compact disc with the label facing upward. Compact disc is extremely Clean the disc or try to play a new dirty or detective disc. one. Temperature inside the car Cool off or until the ambient is too high. temperature return to normal. Condensation. Leave the player off for an hour or so, then try again. No sound. Volume is in minimum Adjust volume to a desired level. Sound skips. The operation keys do not work. The radio does not Work. The radio station automatic selection does not work. Wiring is not properly connected. The installation angle is more than 30 degree. The disc is extremely dirty or defective disc. The built-in microcomputer is not operating properly due to noise. The antenna cable is not connected. The signals are too weak. Check wiring connection. Adjust the installation angle less than 30 degree. Clean the compact disc, then try to play a new one. Press the RESET button. Front panel is not properly fix into its place. Insert the antenna cable firmly. Select a station manually. 14