Pyle PLCDBT65MRW User Manual - Page 4
Removing the unit
View all Pyle PLCDBT65MRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashbSopriangrWda.sher Hex Nut Metal Strap Mounting Bolt Plain Washer Tapping Screw Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring. Removing the unit Make sure the ignition is turned off, then disconnect the cable from the vehicle battery's negative (-) terminal. Remove the metal strap attached the back of the unit (if attached). Lift the top of the outer trim ring then pull it out to remove it. Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard. 4