Pyle PLD10BT PLD10BT Manual 1 - Page 9

GENERAL KNOWLEDGE ABOUT REMOTE CONTROL 1. Removing insulating sheet If using remote control for the first time, you can see an insulating sheet at the bottom side of remote control as right. you must remove the insulating sheet as right. Otherwise, the remote control is disabled. 2. Replace lithium cell If the electric energy of lithium cell is weak, replace it. 1) Press and hold the movable block as direction indicated by arrow 1 as right, at one time pull cell holder out of remote control as direction indicated by arrow 2 as right. 2) Replace the old cell by a new one with (+) polarity side upward as right. 3) Insert the cell holder into remote control again as right. 3. Note about using remote control 1) You should face the emitting window of remote control towards the sensor window of the unit. 2) Operation angle for front panel: About 30 degree 3) The distance between the emitting window of remote control and the sensor window of the unit : < 5M . 4. Warning for lithium cells of remote control 1)Cell leakage may cause damage to remote control. 2)Do not throw cells into fire, it may cause explosion. . 3.To avoid risk of accident, keep cells out of reach of children. -7-