Pyle PLTT82BTBK Instruction Manual - Page 4

Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it in the direction of the arrow. Discard the stylus cover. Remove the twist-tie that was used to secure the tone arm during shipment. TONE ARM LOCK LEVER Release the tone arm lock lever. Connect the plug to your AC outlet. STYLUS COVER POWER SOURCE This system is used dc adaptor operate on normal 120V 60Hz DC only. Attempting to operate from any other power source may cause damage to the system, and such damage is not covered by your warranty. NOTE: If this plug will not fit into your outlet, you probably have an out-dated non-polarized AC outlet. You should have you outlet changed by a qualified licensed electrician. The DC adaptor output DC 12V, push in DC jack. Please pull the power plug during shock and unused for a long time. The power plug and power jack should be matched as a suitable make and break device, in order to make operation conveniently. IMPORTANT: Raising And Lowering The Lid To open the lid, raise it as far as it will go until the lid support bracket 'locks' in the open position. To close the lid, lift it upward slightly until the lid support bracket 'unlocks' , and then gently lower the lid. TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED. ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET. PROTECT YOUR FURNITURE This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These'feet'are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and home improvement centers everywhere. 3