RCA D770 Owner/User Manual: D770 - Page 6

Programming The AUX1 And AUX2 Keys You can assign any one of the following components to the AUX1 or AUX2 keys: A second TV, VCR, DVD, satellite system, cable box, or an audio component. Note: The AUX1 key is pre-programmed with codes to control Dish Network digital satellite receivers. The SAT key is pre-programmed with codes to control RCA DIRECTV digital satellite receivers. If you wish to control a second RCA DIRECTV digital satellite receiver, program the AUX1 or AUX2 key with satellite code 5001. Then refer to your RCA DIRECTV satellite receiver manual for instructions on remote control setup. 1. Manually turn on the component you wish to control. Find the four-digit code for the component you wish to program in the code list. 2. Press and hold the AUX1 or AUX2 key. While holding the AUX1 or AUX2 key, press the first number of the component code. If the first number is valid, the LED will turn off. 3. Enter the code using the DIGIT (0-9) keys. After your full code is entered, the LED light will turn on to verify that the code entered is valid. Release the component key. The LED will go off. Note: If the code is invalid, the LED light will flash four times and the remote will revert back to normal operation maintaining the current code. 4. Aim the remote at the component you wish to control and press the ON•OFF key. The component should turn off. Note: If the component you have programmed does not respond, try all the codes for your brand. If the codes do not work, or your brand is not listed, try the Automatic Code Search method on pages 8. 5. With your component on, press CH+ (CHANNEL UP) or the ON•OFF key. If the component responds, no further programming is required. 6. Enter your code here and then check the type of component you programmed for easy reference. AUX1 CODE (OFF) (OFF) OR AUX2 CODE TV VCR DVD CABLE SAT AUDIO ✓ TV VCR DVD CABLE SAT AUDIO ✓ 7