RCA LED42A45RQ User Manual - Page 10

TV Stand Installation TV LED42A45RQ is packaged with the base of TV stand separated from the cabinet. To setup the base of TV table stand, please carry out the installation according to the instructions below. Step One Place the TV faced down on a soft cloth or cushion to prevent the LED LCD panel from being damaged. Note: 1. The LED LCD panel can be scratched easily, so please choose an absolutely flat surface to place the TV, and use soft cloth or cushion to protect the TV panel. Do not put TV on table directly. 2. Always unplug the AC cord first when installing or removing the stand. TV Back cabinet Step Two Take the base of stand. You should take notice of direction about base installation, please refer to the picture given right side: Step Three TV Front cabinet Please align the six holes of the base and six screwholes of the neck (align the location labels on the back of base and neck), then insert the base to the neck. Step Four Then insert PWA4*12 screws (all same in size) and tighten them. Please refer to the picture given below: The bottom view of the TV ( Front cabinet faces down) Pedestal Screws Quantity Part # PWA4 x 12mm 6pcs RS01PWA412H Note: 1. Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over. 2. Make sure to distinguish between the front and back of the Stand base. 3. Make sure that at least two persons lift and move the TV. ! Do not insert your fingers into the stand base slot of the TV when installing the stand base. 9