RCA RCU 300 Owner/User Manual: RCU300T - Page 13

RCU300_US_IB_REVC 7/16/03 15:17 Page 13 Problem: The remote is not performing commands properly. • You must put the remote in the correct mode by pressing the corresponding component key (TV, VCR•DVD, DBS•CABLE) so the remote knows which component you want to operate. • Make sure component is "ready" (e.g., DVD player has disc loaded; VCR has tape loaded, etc.) • You may have pressed an invalid key for the mode the remote is in (for example, REC only works in VCR mode). • If you're trying to turn on an RCA, GE or PROSCAN component, press the component key (TV, VCR•DVD, DBS•CABLE) instead of the ON•OFF key. • If operating a VCR to record, you must press the REC key two times. • If you're trying to change channels, try pressing the ENTER key after entering the channel number as this is a requirement of certain models and brands. • There is a possibility that a programmed code may only be able to control some of your component features (e.g., only turns a component on and off). Follow the steps provided for programming the remote (See Programming Sections on pages 5-7). If the component can be turned on and off, make sure you press the CHAN UP/DOWN key to see if the component responds. If not, try the next code from the list. Problem: The VCR won't record. • As a safety feature, you must press the REC key twice to begin recording. • Make sure the tape is properly loaded in the VCR. • Make sure the tape is not write-protected. If the safety tab is removed the tape is write-protected and you cannot record onto that tape. Problem: The remote will not change channels. • You must put the remote in the correct mode by pressing the corresponding component key (TV, VCR•DVD, DBS•CABLE) so the remote knows which component you want to operate. • Press the ENTER key after you enter a channel number. Problem: The component's menu doesn't appear on the TV screen. • The TV must be tuned to the Video Input that matches the manner in which you connected the component to the TV. For example, if you connected your DVD player to your TV by connecting audio/video cables (usually colorcoded yellow, red, and white) to the TV's Input 1 jack, you must tune the TV to its Video Input 1 channel. Remember, different manufacturers label these jacks differently. Consult the instruction manual that came with the TV for more information. • You must put the remote in the correct mode by pressing the corresponding component key (TV, VCR•DVD, DBS•CABLE) so the remote knows which component you want to operate. • Menu access isn't supported for all brands. If that's the case, you'll need to use your original remote control to access menu functions for these components. If you have further questions, please visit www.rca.com. 13