RCA RCU 300 Owner/User Manual: RCU300T - Page 6

RCU300_US_IB_REVC 7/16/03 15:17 Page 6 Program for DVD or VCR- Direct Entry Method In order for the 3 component universal remote to control your DVD or VCR, you must program it with the code that matches your component. The VCR•DVD key can be programmed to operate either a DVD or a VCR player. These instructions explain the preferred method of programming the remote- the Direct Entry method. 1. Manually turn on the VCR or DVD player. CODE INDICATOR SEARCH LIGHT VCR• DVD (BLINK) 2. Locate the enclosed VCR or DVD Code List. Find your brand in the VCR Codes or DVD Codes section, respectively. Note: If your brand isn't listed, use one of the Code Search methods to program this remote control (See Code Search on page 8). 3. Press and hold the CODE SEARCH key until the indicator light illuminates. Then release the CODE SEARCH key. 123 456 4. Press and release the VCR•DVD key. The indicator light blinks and then remains lit. 789 0 5. Use the number keys on the remote to enter the first code listed for your brand. After you enter a valid three-digit code, the indicator light turns off. (OFF) ON•OFF Note: If you enter an invalid code, the LED will flash rapidly for 2 seconds. Start over at step 3. 6. Aim the remote at the component (VCR or DVD player). Press the ON•OFF key. If your VCR or DVD player turns off, you have found the correct code. VCR OR DVD CODE 7. Enter the code in the box provided on this page for future reference. 8. If your VCR or DVD player doesn't turn off, repeat steps 3-6 above, entering the next code for your brand. If none of the codes work or your brand is not listed, use one of the Code Search methods to program this remote (See Code Search on page 8). For a description of each key on the remote control, refer to the Key Descriptions section on page 3-4. 6