RCA RP5030 User Manual - RP5030 - Page 13
Recording Mode - - manual
View all RCA RP5030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
RP5030 EN (B ver) 15/11/06 10:28 AM Page 14 Recording Mode Setting Recording Mode 5. Press RECORD to enter AVR mode. 6. During AVR on EN You can select between two recording, adjust recording modes - manual recording the sensitivity of the and AVR (automatic voice recording). microphone by AVR pressing VOL UP 1. Manual Recording and VOL DOWN, 1. In STOP mode, select folder (A, B, SEN with sensitivity C , D or ). value shows on 2. Press RECORD to start recording. display (e.g. 3. To pause recording, you can press increase sensitivity AVR RECORD once, press again to value when resume recording. 4. To stop recording, press STOP. recording source is far from the unit or A the recording AM envionment is quiet.). DICT SP AVR Tip: To view the remaining time and other recording information, you may press PLAY during recording. 7. Start dictation. Recording starts automatically. 8. Press STOP to end AVR recording. 9. Repeat step 2 and select AVR OFF 2. AVR (Automatic Voice for de-selection. Recording) This feature allows the unit to sense sound and to record only when you are speaking into the microphone. When dictation stops for about 3 seconds, recording will stop and then start again automatically when you resume dictation. 1. Select destination folder (A, B, C , D or ). 2. Press MENU four times. 3. Press REVERSE or FORWARD to toggle between AVR on and AVR off. 4. Press STOP to exit to STOP mode. Tip: The first syllable or two may be lost when you start recording because this 'sound' is used to turn on the AVR feature. It is a good practice to make some 'sounds' or say a short word to activate the AVR before you begin actual dictation. 9