RCA RS3965SB RS3965SB Product Manual - Page 9

Clock and Timer Setting the clock 1. Press and hold CLOCK until the hour flashes on the display. 2. Press / to set the hour and then press CLOCK to shift to minute digits. 3. Press / to set the minute. 4. Press CLOCK to save settings. • When system is ON, you can tap CLOCK to display the current time - it will display time for about 2 seconds. Sleep mode You can select the time interval in minutes before the unit turns off automatically. 1. Press SLEEP to select among OFF, 120, 90, 60, 45, 30, 15, 10 and 5 minutes. The sleep icon lights on the display when sleep mode is activated. 2. When sleep is activated, press SLEEP once to view remaining sleep time. Press SLEEP again when the remaining sleep time is displayed to change the sleep time. • Sleep is automatically de-activated when the unit EN is turned off. Sound Features Setting the timer • For RADIO timer, tune in to a desired station. • For CD timer, insert a CD into the unit. 1. Press and hold TIMER until ON (timer on time) appears with the hour flashing. 2. For setting time, press / to set the hour and then press TIMER to shift to the minute digits. 3. Press / to set the minute. 4. Press TIMER to change to OFF (timer off time) with hour flashing. Repeat steps 2 & 3 for timer off time setting. 5. Press TIMER to select the source. Press / to select among TUNER, CD or BT (Bluetooth). 6. Press TIMER to set the volume. Adjust the timer volume by pressing / to select the desired volume level. Note: To avoid startling you or other individuals in your home, this product will not turn on at a volume higher than 15. 7. Press TIMER to save settings. Activating the timer Tap TIMER to turn on/off the timer. The timer is active when the clock icon is lit. Bass boost Press BASS to turn on/off boosting the bass frequency. The BASS icon lights on the display when it is activated. Muting audio Press on the remote control to cut or restore the sound. Using preset equalizer curves Press EQ on the unit to select among FLAT, ROCK, POP, JAZZ, CLASSIC and CUSTOM. The display shows your selection briefly. Creating a Custom Curve 1. Press EQ on the unit to select the CUSTOM mode. 2. While CUSTOM is displayed, press / to cycle among the displayed BASS and TREB range levels. 3.While BASS or TREB is displayed, adjust the volume to set the associated gain between -10 - +10. 4. Press EQ to exit. - 8 -