Reebok 8400c Treadmill English Manual - Page 13
Note: For sim
View all Reebok 8400c Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
The lower right corner of the display will show the distance that you have walked or run, the elapsed time, your pace in minutes per mile, and the speed of the walking belt. Note: When a program is selected (except for custom programs and heart rate program 13), the lower right corner of the display will show the time remaining in the program instead of the elapsed time. The center of the display is the priority display. Press the Display button repeatedly until the priority display shows the information that you want to view. Note: While information is displayed in the priority display, the same information will not be displayed in the lower left or right corner of the display. Note: The console can display speed and distance in either miles or kilometers. To change the unit of measurement, see THE INFORMATION MODE/DEMO MODE on page 19. Note: For simplicity, all instructions in this section refer to miles. To reset the display, press the Stop button, remove the key, and then reinsert the key. 6 Measure your heart rate if desired. Note: If you use the handgrip pulse sensor and the optional chest pulse sensor at the same time, the console will not display your heart rate accurately. To use the handgrip pulse sensor, first remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean. Next, stand on the foot rails and hold the metal contacts-avoid Contacts moving your hands. When your pulse is detected, the heart symbol in the lower left corner of the display will appear, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 7 Turn on the fans if desired. To turn on the fans, press the Fan button. To turn on the fans at high speed, press the button a second time. To turn off the fans, press the button a third time. Note: If the fans are left on when the walking belt is stopped, the fans will automatically turn off after a few minutes. 8 When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will become damaged. Next, remove the key from the console and put it in a secure place. Note: If the display remains lit after the key is removed, the console is in the "demo" mode. See page 19 and turn off the demo mode. When you are finished using the treadmill, switch the reset/off circuit breaker to the "off" position and unplug the power cord. 13