Reebok 8400c Treadmill English Manual - Page 6

ASSEMBLY Assembly re1quires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench and your own phillips screwdriver , wire cutters , and rubber mallet . Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. To identify small parts during assembly, use the part identification drawings below. To avoid damaging plastic parts, do not use power tools for assembly. Nut (20)-2 3/4" Tek Screw (65)-2 1" Tek Screw (100)-4 1 1/4" Tek Screw (71)-2 Handrail Star Washer (77)-2 Foot Screw (74)-2 Wheel Bolt (94)-2 Console Bolt (78)-2 1. With the help of a second person, carefully raise the 1 Uprights (69) to the position shown. Next, insert one of the Extension Legs (102) into the base of the Uprights (69) as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is underneath it. Note: It may be helpful to tip the Uprights forward and use a rubber mallet to fully insert the Extension Leg. Insert the other Extension Leg (not shown) in the same way. 69 102 99 6