Reebok Rt 245 Bike English Manual - Page 7
Note: The Nylon Locknuts and Split
View all Reebok Rt 245 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
8. Attach the Seat (12) to the Seat Post (11) with four M8 Nylon Locknuts (56) and four M8 Split Washers 8 (28). Note: The Nylon Locknuts and Split Washers may be pre-attached to the Seat. Turn the Seat Knob (31) counterclockwise two or three turns to loosen it. Next, pull the Knob, insert the Seat Post (11) into the Frame (1), and then release the Knob. Slide the Round Collar (13) down the Seat Post and press it into the Frame. Attach the Round Collar to the Frame with an M6 x 8mm Screw (26). Move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwise until it is tight. 12 11 13 28 1 56 26 31 9. Identify the Left Pedal (40); the threaded shaft on each Pedal is marked with an "L" for "left" or an "R" for "right." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Crank Assembly (33). Tighten the Right Pedal (not shown) clockwise into the Crank Assembly. Important: Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened. Identify the Left Pedal Strap (41), which is marked with an "L." Attach the Left Pedal Strap to the Left Pedal (40), and adjust the Left Pedal Strap to the desired position. Attach and adjust the Right Pedal Strap (not shown) in the same way. 9 33 41 40 10. Attach the Water Bottle Holder (63) to the Frame (1) 10 with two M4 x 19mm Screws (59). Note: The water bottle holder is designed to be used with your own water bottle. 59 63 1 11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some hardware may be left over after assembly is completed. Place a mat under the exercise cycle to protect the floor or carpet. 7