Reebok Rt 300 Bike English Manual - Page 7

4. Attach the Water Bottle Holder (18) to the Handlebar Post (6) with two M4 x 19mm 4 Screws (33). 6 18 5. Have a second person hold the Handlebar (7) near the Handlebar Post (6). Insert the Controller Wires (54) into the hole in the Handlebar Post and pull them upward out of the top of the Handlebar Post. Attach the Handlebar (7) to the Handlebar Post (6) with two Black M10 x 50mm Button Screws (64), two Black M10 Curved Washers (61), two M10 Curved Washers (36), and two M10 Nylon Locknuts (48). Be careful to avoid pinching the wires. 5 48 36 36 6 33 55 Hole 54 7 61 6. The Console (9) requires four 1.5V "D" batteries (not included); alkaline batteries are recommended. Press the tab on the battery cover and remove the battery cover. Next, insert four batteries into the Console. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Then, reattach the battery cover to the Console. 6 Battery Cover Batteries 61 64 9 7. Note: A long cable may be attached to the 7 Console (9). The long cable is used during the man- ufacturing process. Remove and discard the long cable before continuing this step. Have a second person hold the Console (9) near the Handlebar Post (6). Connect the console wire harness to the Upper Wire Harness (55). Next, connect the game wire that has a tag to the Controller Wire (54) that has a tag. Then, connect the other game wire to the other Controller Wire. Attach the Console (9) to the Handlebar Post (6) with four M4 x 16mm Screws (58). Be careful not 58 to pinch the wires in the Console. 9 Game Wires 54 6 Console 55 Wire Harness 7